The Simulation of Thermomechanically Induced Stress in Plastic Encapsulated IC Packages

Download or read book The Simulation of Thermomechanically Induced Stress in Plastic Encapsulated IC Packages written by Gerard Kelly and published by Springer Science & Business Media. This book was released on 1999-04-30 with total page 170 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book is motivated by the need to understand and predict the complex stress distributions, transfer mechanisms, warpage, and potential failures arising from the encapsulation of devices in plastic. Failures like delaminations, package cracking, and metal shift occur due to the build-up of residual stress and warpage in the packages because of the TCE mismatch between the package materials as the package cools from its molding temperature to room temperature. The correct use of finite element tools for these problems is emphasised. F.E. techniques are used to predict the internal package stress distribution and help explain the stress transfer mechanism between the die, die paddle, and plastic after molding. Out-of-plane shear stress components are shown to be responsible for experimentally observed metal shift patterns on the die surface. Delaminations dramatically alter the internal stress state within a package, increasing the tensile stress in the plastic and so the likelihood of plastic cracks, the stress on wire bonds, and the incidence of wire bond failure. The application of F.E. techniques to predict the post-mold warpage of both thermally enhanced PQFPs and TQFPs is described. Simulations of a thermally enhanced PQFP warpage based on standard modelling assumptions alone fail to predict either the magnitude or its direction correctly. The modelling assumptions need to be modified to include the chemical shrinkage of the molding compound to enable accurate predictions of package warpage to be made, particularly when the packages are asymmetric in structure. Microsystem packaging in both plastic and 3D package body styles is reviewed. Although microsystem packaging is derived from IC packaging, additional requirements for microsystems, not common to IC packaging are highlighted. The assembly stresses on a novel microsystem, incorporating a micromachined silicon membrane pump integrated into a 3D plastic encapsulated vertical multichip module package (MCM-V), are analysed.